Problem With “pri Show Channels” On Rasterisk (11.7)

Home » Asterisk Users » Problem With “pri Show Channels” On Rasterisk (11.7)
Asterisk Users 5 Comments

Hi,

I’m running a test system with Ast 11.7 and DAHDI 2.9.0. I loaded a TE205P
card. Then I enter asterisk console, and once I do a “pri show channels”, the console no longer works correctly. There’s no output for any command after that. If I type “pri show” and hit tab for completion, console freezes there, I need to kill session.

Any hints? new bug? known issue?

Tks

5 thoughts on - Problem With “pri Show Channels” On Rasterisk (11.7)

  • As the owner of a TE205P, it might be easiest to contact Digium’s technical support for installation assistance.

    I personally am not aware of any general issues when running “pri show channels”

  • Indeed, I tested two more cards on this system, and I don’t get the same problem with them. Unfortunately, different models (TE122P and TE110P), but still it seems to suggest a problem with the TE205P. Weird manifestation though, because everything else seems ok with, even a patlooptest is just fine. Too bad it’s OOW by now 🙂

    Thanks.

  • I would be very surprised this has anything to do with the TE205P
    specifically. The command “pri show channels” does not result in any calls to the drivers. My guess is this has more to do with the state
    / configuration of Asterisk.

  • I actually meant that card specifically, not a general issue with the model.

    But I defer more considerations to when I have the chance to test another TE205.