Is the Asterisk internal database cached by Asterisk?Or is it always reading/writing to the SQLite database?(If I read from the SQLite DB is it sure to match what Asterisk..
Author : Technical Support
I am setting up a system with a large number of trusted trunks (by IP).Ifind that I have to make one entry sip.conf for each trunk becauses the host= line requires a single IP. Does asterisk support a CIDR or wildcard or multi-ip format for the hostl..
Does reloading pbx_config ONLY reload the dialplan?Or is something else reloaded too? This sounds like a preferable way to do it From: Ian McMaster [mailto:ian.mcmaster@gmail.com] Sent: Saturday, April 20, 2019 1:19 PMSubject: Dialplan reload from ..
I see there is a modulereload function available from the AMI, but none of the listed modules (on the wiki) seem to reload the dialplan.Is there a way to reload the dialplan through this function?Or do I have to use thecomma..
I have 2 PBXs, one in each office (say one in New York, one in Boston).Ihave mobile users that can show up at either office and connect their soft phones. Is there a very simple DUNDI config available which describes how to set this up?Also, can I h..
I know this was discussed years ago – but Im looking into whether things have changed.Imagine this scenario: 1. Phone A call Phone B through Asterisk.(A — > Asterisk — > B)2. All 3 devices have public IP addresses, and Asterisk is configured for directme..
I have an Asterisk system with 2 trunks (as shown below).I need to be able to disable a trunk at runtime. I may not change the dialplan but I can change sip.conf and reload. Any attempt to dial in the dialplan uses trunk A and trunk B in that ord..
Does anyone know if Asterisk 16 includes changes to the AMI?(syntax /commands / etc) I see a release candidate is forthcoming.Ju..
I want to get a list of all active channels from the AM.Ive been usingcore show channels concise (as a commands from the AMI) but I see in the documentation that the command is deprecated and will be removed. Whats the best way to get the equival..
I need to create a SIP proxy to be placed in front of a legacy PBX.When a phone registers with the proxy, I would like Asterisk to register with the PBX behind it.(To tell the PBX to send calls to the proxy and then to the SIP phone). Can I use Aster..