Passing Caller ID Through Digium Gateway

Home » Asterisk Users » Passing Caller ID Through Digium Gateway
Asterisk Users 1 Comment

Hi All,

I’ve setup a Digium G100 VoIP gateway to replace an internal PCI VoIP
card in our Asterisk PBX. When using the VoIP card the callerid entries listed in sip.conf were displayed when calling someone over the PSTN.
Now, however, though the gateway it just displays the default number assigned to our PRI. I’m wondering if anyone having experience with the Digium gateways can point me in the right direction to have the gateway respect the callerid entries listed in sip.conf. We are using an older Asterisk 1.6 build.

Thanks in advanced for the help!!

Ferdinand

One thought on - Passing Caller ID Through Digium Gateway

  • We use G100 and 200s at a few of our sites and caller id passes through just fine. Check under Configuration -> call routing rules to make sure you don’t have a caller ID name and number set in there. You have to take it off of Simple Entry Mode to see the options.

    Also, on your SIP Endopoint configuration, under the call settings tab, make sure you have your Caller ID Presentation set correctly. From the help on that option:

    Caller ID Presentation:Handles Caller ID presentation on outgoing calls. Allow for prohibiting Caller ID presentation, and defines whether the information has been screened by an authoritative source. Options other than screening, allowed, and prohibited indicate that the Caller ID was provided by the network.