Cdr Table’s “dst” Column

Home » Asterisk Users » Cdr Table’s “dst” Column
Asterisk Users 3 Comments

Hi All

What, by definition, goes to the cdr table’s “dst” column ??

In our setup, to get outside the user has to dial X before any number. This goes to the dst with the X stripped out.

I recently made some changes in a macro and after that the X appeared in this dst column!

I run through the script and see no differences between the old and the new one.

Then the question: What, by definition, goes to the cdr table’s “dst” column ??

Is it the “identifier” field from the Dial command?

Regards

Ethy

3 thoughts on - Cdr Table’s “dst” Column

  • The value of the dst column is the number you dialed. If you dial
    9 to get an outside line, that 9 will be in the dst field unless you manipulate the value. At least for me this has always been the case.

  • Ethy,

    The number that is recorded in “dst” is the last EXTEN in your dialplan, so if you need record another number you can create a new context and change to this context with Goto.

    Follows an example:

    exten = _9X.,1,Dial…

    And you need to record without “9” you can do this:

    exten = _9X.,1,Goto(context,${EXTEN:1},1)

    and in your new context this:

    exten = _X.,1,Dial…

    Rgs,

    Att, H

  • Hmmm!!

    That solved the issue.

    One of the modificativos I did was to remove an “unnecessary” Goto!!

    Thanx Regards

    Ethy