Any one having this problem. The Grandstream Firmware revision is 188.8.131.52. We have the registration time set to 5 minutes, and every time after a reboot, the BLFs will initially indicate the correct state, then stop working a few minutes later. The workaro..
My customer needs to set a forwarding based on number of rings,i.e., if the phone rings 5 times (user-selectable), then try another number. Is there a way to do such a thing with Asterisk? I could not find way to do it based on the documentation of ..
all, We are encountering some problems with the queuemanager in some specific cases. When an agent gets a call from a queue the agent gets a wrap-up time after the call is finished, so far so good. When the call enters the queue while being transfer..
Hello Up to version 1.6.0 we have been ableto configure the same SIP device as a user [inbound trunk] and as a peer [outbound trunk] w/o issues. After we switched to version 1.8 this setup wont work, apparently one can not have the same IP on 2 differ..
Lately I have been getting many complains that Eyebeam crashes when you dial a number that does not exist.This happens in both R2 and ISDN PRI lines.The softphone stops working and has to be restarted.The response I got from tech support was: the act..
I am using asterisk 184.108.40.206. when I am sending dtmfs the first digit is not
Do you know a workaround for this?
_____ From: firstname.lastname@example.org [mailto:email@example.com] On Behalf Of vip killa Sent: Wednesday, February 23, 2011 10:11 AM To: Asterisk Users Mailing List – Non-Commercial Discussion Subject: [asterisk-use..
There is a problem when transferring calls using REFER, asterisk does not notify dialplan. Ive been told to use AMI as a workaround to notify my dialplan/routing program but that would require a huge change to our software. I was wondering if there..
I was curious to know if anyone has had any luck getting Cisco phones working with Asterisk and chan_skinny?Specifically, a Cisco 7920. If a SIP firmware was available, Id just use that.It works fine with chan_sccp and 1.6, but my understanding is t..
We recently upgraded to Asterisk 1.8/DAHDI 2.4/WANPipe 3.5.16. This system is connected to a PRI where the provider requires long distance codes. Normally, you dial, see progress and hear a tone (call is still unanswered at this point), enter your co..