Hello!I migrated asterisk 11 to 13 as user of FreePBX 18.104.22.168.As customer of German Telekom, I have three numbers and therefore three trunks – each number is bound to one trunk.After migration, some callers complained about missing ringback tone:t..
For lab testing, Im trying to build two differents PJSIP trunks between twoAsterisk 13.8.0enabled boxes. I thought I could set up both trunks like this:Box A/port 5060 Box B/port 5060Box A/port 5062 Box B/port 5062and declare trunks like this:[foobar1]type=endpo..
– I have 2 Asterisk servers connected using 05 IAX2 trunks. I want to load balance incoming calls over IAX2 trunks. If any trunk goes down the calls traffic will be shared with other available trunks. When it gets Up the script is supposed to perf..
everyone!I have a system that integrates both ISDN and R2 trunks. Is there any way to check the status of the trunks?I need to create a program that automatically verify the connection status of the trunks.Th..
Ive searched the asterisk.org and voip-info wiki sites, but not found an answer that seems to match.Hopefully this is a simple question. COLP is working very well on our system – Unfortunately it is working a bit TOO well in some circumstances. We h..
all, Ive tried to explicitly set my two PSTN trunks/FXO lines to alaw with: alaw = 1-2 in /etc/dahdi/system.conf. However, when I do this, all I get is loud intense noise on the line and nothing else – cant dial, cant make calls, cant receive cal..
Im reading some information that recommends using SER / OpenSER for large installation to offload SIP traffic from the Asterisk server. http://www.voip-info.org/wiki/view/Asterisk+at+large However, it looks like the information might be dated. Im look..
I have setup Dahdi with Sangoma FXO A200 card and asterisk 1.8 , everything seems fine and working perfectly incoing/outgoing. but one major issue is, when i made an out call from dahdi trunks and when a number is in ringing state it gives me an ans..
Does anyone how I could extract redirected number from a sip packet I have redirected a cell to a second cell which also rings a sip trunks and wish to route the call per rdnis The rdnis variable brings the first redirect (divert) which is the sec..
I have a situation where unfortunately, I cannot use IAX for trunks, and need to instead use SIP trunks. Is there any way to fit the voice data from more than one simultaneous phone call into a single IP packet over the SIP trunk. I believe this is possi..