The flowroute website mentions that they set callerid on outbound calls based on the presence of (in order of preference):P-Asserted-Identity, Remote-Party-ID..
Due to high volume of outbound calls you might be asked to alternate the outbound traffic by your termination provider.Basically, what what you need to do here is: Having 2 destinations (Dst_A, Dst_B), check/set a variable in the AstDB. Then if the varia..
I have 8 E1 PRI Lines and i have 200 phone numbers and 200 channels (25 channels per PRI). is there a utility available in Asterisk to dial out 200 numbers and run a campaign for 200 numbers concurrently and play a mp3 file ? Please suggest/guide Rega..
I am still having major issues with dtmf recognition. My setup is Polycom end points. Tried this with different models, firmware and cfgs. Outbound calls are not going out reliably. Phones are set to rfc2833. I have had sangoma and elastix support l..
I am having a problem registering my cisco phones which is exactly like that described in http://lists.digium.com/pipermail/asterisk-users/2011-May/262306.html except that I am on Asterisk 184.108.40.206 and using sip level POS3-07-4-00 The symptoms are..
Is there a step by step guide to Configure IVR(Inbound and Outbound) in
AsteriskNow using FreePBX ?
Is it possible to have a call file enter the dialplan, and then initiate 2 outbound calls and then bridge them?
Does anyone knows how to find outa call in a asterisk is external
incoming ,external out going or internal
, how can I set up an peer, so that behind one IP (NAT) multiple devices can access to this single peer to make outbound calls. Some of these multiple devices will be SIP phones and these SIP phones are trying to make registrations to this peer. b..
Greetings- First, my apologies for the OT post. Yes, I understand this is not the FreePBX-users mailing list. But, there are a large number of people that use FreePBX and Im hoping they can be of assistance. I have a system running Asterisk 1.4.27 (see..