I have a problem for received calls form my Grandstream HT-503. I have a FXO connect to my PABX, and I can make a call from PABX to VOIP, but I didnt received calls to my VOIP, t..
I have a current asterisk 22.214.171.124 asterisk-addons 1.6.24 asterisk-sounds 1.2.1 dahdi-linux-complete 2.6.1+2.6.1 libpri 1.4.12 and asterisk-gui 2.1.0.rc1 (not trying to use the gui, want to do everything by hand) with a TDM410 with 2FXO and 2FXS.I h..
Ade- > Does anyone do a low profile PCIe FXO card? I just picked up an HP ProLiant > microserver for $nuppence, which Id hoped to migrate my Asterisk setup > onto. I currently use an A400P analog card, but the ProLiant only has PCIe > slots, and the..
On Sun, May 6, 2012 at 12:42 PM, Greg Woodswrote: > I have a Digium TDM400P card that appears to have died. The first noted > symptoms were that dahdi would fail to reload on boot. On closer > inspection, the card looks totally dead; no lights on..
On 05/06/2012 11:42 AM, Greg Woods wrote: > Second, since the parts of this card are very expensive, I am wondering > if these symptoms likely mean that the main board of the card is dead, > but the FXS and FXO modules might still be good. In that ca..
I have a Digium TDM400P card that appears to have died. The first noted symptoms were that dahdi would fail to reload on boot. On closer inspection, the card looks totally dead; no lights on at all. I have tried moving it to a different PCI slot, ..
First of all, I want apologize for the first two blank emails that I sent out by mistake. I have Xorcom USB fxo channel bank, asterisk 1.6, freepbx 2.8. Up to now, the lines connected from Telekom did not have caller id feature enabled, now that we enab..
I have a TDM410 with one FXO and one FXS.Ive been running dahdi 126.96.36.199 without any problems. A couple of weeks ago I upgraded to 2.6.0 and found that caller ID was no long working for me.All calls came in with a blank caller id.I reverted back to 2.5…
all, Ive tried to explicitly set my two PSTN trunks/FXO lines to alaw with: alaw = 1-2 in /etc/dahdi/system.conf. However, when I do this, all I get is loud intense noise on the line and nothing else – cant dial, cant make calls, cant receive cal..
Hy all, Recently a have a little problem with a Cisco device,SPA3102. I use this device with asterisk to dial out with outbound trunk. (SPA3102 has 1 FXO port) It working ok , but the device SPA3102 do this : when a call is placed for outgoing in aster..