Im looking for a method to setup FoIP i.e. using T.38 protocol with no PSTN lines. I tested T.38 feature for Asterisk but the problem Im getting is unable to send more than 2 pages but getting timeout error. Past couple of years I also configured ..
I recently switched to a PRI from analog lines. For reasons out of my control, my vendor had problems getting the PRI to interface so they set it to use T1-CAS instead. The lines are working just fine for inbound and outbound calls, except I get no c..
A quick look at Digiums Fax for Asterisk datasheet shows a maximum 14.4
kb/s speed which is fine, but Im wondering if its possible to achieve
reliable 33.6 kb/s faxing (with a Digium board based Asterisk system) ?
On May 20, 2011, at 3:30 PM, Anthony Messina wrote: > On 05/20/2011 01:20 PM, email@example.com wrote: >> #1) We would like to use Fax For Asterisk with asterisk 1.8.4 in order to receive faxes via T.38.Sending faxes is not a requirement.Does anyone h..
On 28/03/2011 5:48 AM, Israel Gottlieb wrote: > still no luck >i hear it change to t38 but it just doesnt connect > Do you have two fax devices at your end, even a fax-modem attached to a computer will do? You are going to need to provide more informat..
OK, I generally use Hylafax+IAXModem for our faxing, but I have been fiddling with FFA and SpanDSP for a while. Is there a good way to determine what version of SpanDSP I have installed and whether the app_fax.so module is the same version? Many than..
I have a setup of asterisk 1.6 in one box and asteirsk 1.4 in another. I
can send recieve faxes from both boxes fine to and from pstn. But the
faxing between 1.6 and 1.4 extensions does fail. Any ideas p..