I have two very much identical systems running Asterisk 11 with the SNMPmodule included.I have found that the order of channel types on the two systems is different. One system has:ASTERISK-MIB::astChanTypeName.1 = STRING: ConfBridgeRec ASTERISK-MIB::astChanTypeNam..
I have a puzzling situation, and would be grateful for any insight.I have a dialplan that forwards an incoming call out to another number via the same SIP trunk as it came in on. e.g.[from-siptrunk]exten => 0123456789,1,NoOp exten => 0123456789,n,Dial(SIP/siptrunk/0987654321)N..
despite some searching I havent found an answer to this question:Is there a way I can see in the log, or find out in the dialplan, what codec has been negotiated for a SIP channel? If possible, Id like to do this in both Asterisk 11 and in an old ..
I am trying to debug a SIP issue, between an Asterisk 1.2.32 system that is behind a network device to which I dont have ready access, which is performing NAT with possibly some kind of SIP ALG, and an Asterisk 11system on a public IP.My question..
I have just installed DAHDI 220.127.116.11 on a system running CentOS 5.11(lets not get sidetracked into discussing the version of CentOS – there are reasons for using it in this case).The system has a TE220 card with 2xE1.It has been working fine, but w..
Are they any gotchas to be aware of in getting Asterisk and Lync 2013talking to each other using SIP? Or is Lync a pretty standard implementation of SIP?C..
I havent been able to find the answer online, and am not currently able to conduct an experiment to find the answer…I understand that in a SIP call where G729 has been negotiated as the preferred codec, a G.729 licence is not consumed until there..
I had a SIP problem on an 11.5.0 system that I look after. It registers with a SIP trunk provider, and at one point the provider had an issue that caused registration to fail.The problem was that Asterisk did not keep retrying, and it was not until..
I have a system running CentOS 5.9 and DAHDI 2.6.2 with a 2-port E1 card using the wct4xxp driver (also using Asterisk 11.5.0, but that isnt relevant to the question).With DAHDI and Asterisk started, the system appears to run normally, as far as I ..
Most of my experience until recently has been in Asterisk 1.2, and I am just starting to make use of Asterisk 11 for new systems.I have a question about using SIP on a multi-homed machine.I have a customer who wants an Asterisk box with two network interfaces:..