Cisco IP Phones and Skinny in asterisk 1.8.4.2 “tooooooooooooooooo”

Home » Asterisk Users » Cisco IP Phones and Skinny in asterisk 1.8.4.2 “tooooooooooooooooo”
Asterisk Users 3 Comments

Hi All;

Again, the Cisco IP Phones 7942G and using Skinny:

I upgraded the firmware to version 8.5 (skinny) and I am using skinny channel (chan_skinny) and the skinny.conf file.

The phones are registering, but when we use them to place a call, we only hear tooooooooooo in the handset and we do not hear voice (even when we dial the digits, we only hear toooooooo .. but it dials and destination answer).

Also if we call to these phones, and we pickup handset of the 7942G, I am hearing toooooooooo and no voice (no one hear voice .. source and destination are not hear).

What about be? Is it related to skinny channel that does not work?

In that case, skinny channel is not working fine and that means, I have to use SIP !

Did any one face like this problem?

Another problem, if I did changes in the extensions.conf and I need to reload, then I can not reload only the extensions.conf, I have to do reload and that will cause a reset for the Phones.

Any advise? Did anyone tried skinny and faced those problems?

Regards
Bilal

3 thoughts on - Cisco IP Phones and Skinny in asterisk 1.8.4.2 “tooooooooooooooooo”

  • i can make bouns mints to asterisk and elastix just give me the ips and i will add mints send the ip or host to
    civic_tito@yahoo.com

    ________________________________
    Sent: Thursday, March 22, 2012 6:28 PM

    Hello,

    Facing the same problem with the following debug skinny log:

      — Asked to indicate ‘Stop tone’ condition on channel Skinny/500@duba-23
    Received Alarm Message: 32: Name=SEP001XXXXX Load= SCCP11.8-3-4SR1S :
    Invalid SCCP message! : ID :83
    Received Alarm Message: 32: Name=SEP001XXXXX Load= SCCP11.8-3-4SR1S :
    Invalid SCCP message! : ID :83

    Did you solved the problem?

    Thanks in advance,

    Alex,

    2011/6/25 bilal ghayyad :