Quoting Michael Nausch :
>> You installed the module, but did you load it in modules.conf?
> No, ’cause the modul should be autoloaded, as on Asterisk 1.6 it has
I know a little bit more, after testing this/last night!
If I start asterisk 1.8 with “service asterisk start” or
“/etc/init.d/asterisk start”, I can’t load chan_misdn.so
If I run asterisk 1.8 as root via “asterisk -vvvc” I can access my
ISDN-card and I be able to dial out to my PSTN provider! 😉
*CLI> == Using SIP RTP CoS mark 5
[Dec 1 10:49:47] ERROR: chan_sip.c:27876 setup_srtp: No SRTP
module loaded, can’t setup SRTP session.