No such device or address

Home » Asterisk Users » No such device or address
Asterisk Users No Comments

I am trying to set up two bords on my server: TDM410p(This on is ok) and TE110p.
This is my system.conf
# Span 1: WCTDM/0 “Wildcard TDM410P Board 1” (MASTER)
# Span 2: WCT1/0 “Digium Wildcard TE110P T1/E1 Card 0”

************************************************************************************And this is my chan_dahdi.conf:

#include dahdi-channels.conf

;General optionsusecallerid = yeshidecallerid = nocallwaiting = yesthreewaycalling = yestransfer = yesechocancel = yesechocancelwhenbridged = yesrxgain = 3.0txgain = 3.0

;FXO Modules
group = 1;echocancel = yessignalling = fxs_kscontext = Troncos-Analogicoschannel = 1,2,3,4

;E1 Modules
And my dahdi-chennel.conf
; Span 1: WCTDM/0 “Wildcard TDM410P Board 1” (MASTER);;; line=”1 WCTDM/0/0 FXSKS (In use)”signalling=fxs_kscallerid=asreceivedgroup=0context=from-pstnchannel => 1callerid=group=context=default
;;; line=”2 WCTDM/0/1 FXSKS (In use)”signalling=fxs_kscallerid=asreceivedgroup=0context=from-pstnchannel => 2callerid=group=context=default
;;; line=”3 WCTDM/0/2 FXSKS (In use)”signalling=fxs_kscallerid=asreceivedgroup=0context=from-pstnchannel => 3callerid=group=context=default
;;; line=”4 WCTDM/0/3 FXSKS (In use)”signalling=fxs_kscallerid=asreceivedgroup=0context=from-pstnchannel => 4callerid=group=context=default
; Span 2: WCT1/0 “Digium Wildcard TE110P T1/E1 Card 0”
signalling = mfcr2channel => 1-15,17-31group=1context=Troncos-Digitais********************************************************************************
In dahdi show status, is shown only the TDM410p board.In dahdi show channels is shown only four analogic trunk
If I type: dahdi restart, I see the following messages:

[Oct 13 14:36:50] WARNING[930]: chan_dahdi.c:2124 dahdi_open: Unable to specify channel 5: No such device or address
This is repeated a lot !!!!


Flavio Roberto Miranda
Skype: flaviormiranda